Citizen CL-S400DT - SA Cover and SA LCD PCB

Chapter 3 Disassembly and Maintenance
3-6 Disassembly, Reassembly and Lubrication
CL-S400DT 3-10
100V
200V
0
1
2
3
4
5
SA FFC LCD
SA Cover
Knob Cover Open
PHT (#2), M3x8 (NI)
BHT (PT), M3x8
Tape
Sheet Ope-Pane
Cover LCD
Logo, CITIZEN
Cover
SA LCD PCB
NO.0, PHT (PT, BK), M2x5
NO.0, PHT (PT, BK), M2x5
Label Adjust Cam
3-6-2. SA Cover and SA LCD PCB
1. Press down the “Knob Cover Open” and open the “SA Cover”.
2. Remove 3 screws (PHT (#2), M3x8 (NI)) and detach the “SA Cover”.
* When detaching, move it backward in the direction of the arrow to let the dial of the body
come off the “SA Cover”.
3. Peel off the tape and disconnect the “SA FFC LCD” from the board.
4. Remove 4 screws (NO.0, PHT (PT, BK), M2x5)) and
detach the “SA LCD PCB”.
5. Peel off the “Sheet Ope-Pane”, “Cover LCD”, “Logo,
CITIZEN” and “Label Adjust Cam” from the “Cover”.
Note on reassembling:
• When inserting the “SA FFC LCD”, hold its blue tape part and fully insert it into the connector of
the “SA LCD PCB”.