Chapter 2 Operating Principles
2-3. Operation Panel
CL-S400DT 2-44
(4-2) Submenu operation in Service mode
The submenu operation procedures in Service mode are explained here. The submenus
other than “Service Counter/Cut Center” and the “Service Counter/Cut Center” submenu
are separately explained.
Operation procedure for submenus other than “Service Counter/Cut Center”:
1. Enter Factory/Service mode by turning on the power while pressing and holding the
[MENU], [FEED] and [STOP] keys.
“Factory Setup” main menu appears.
2. Press the [MENU] (T) or [FEED] (S) key until “Service Mode” main menu appears.
3. Press the [STOP] (X) key to enter Service mode.
4. Press the [MENU] (T) or [FEED] (S) key until a desired submenu (e.g. “Head
Check”) appears.
5. Press the [STOP] (X) key to select that submenu.
* For submenus “ROM Check”, “RAM Check”, and “Print Counter”, the result is displayed
and further operation is not necessary.
* For submenu “Head Check”, the following screen appears and prompts you whether to
perform the head check or not.
* For submenu “Motor Feed”, the following screen appears and prompts you whether to
feed media forward or backward.
[When “Head Check” is selected] [When “Motor Feed” is selected]
6. Press the [MENU] (T) or [FEED] (S) key and select “Yes” (when “Head Check” is
selected) or “Forward”/”Back” (when “Motor Feed” is selected).
7. Press the [STOP] (X) key to perform the selected item.
* When “Head Check” is selected, the number of defective dots of the thermal head is
displayed.
* When “Motor Feed” is selected, the PF motor turns to feed media forward or backward.
[When “Head Check” is selected] [When “Motor Feed” is selected]
8. Press the [PAUSE] (W) key to return to “Service Mode” main menu.
9. To check other submenu, repeat from Step 3. Otherwise, turn off the power to
terminate Factory/Service mode.
Service Mode
Head Check
S
T
Check
No
S
T
Feed
Forward
S
T
PASS
0000dots
Feed
Back
S
T
To Next Page
Loading...
