Citizen CL-S400DT - Page 58

Chapter 2 Operating Principles
2-3. Operation Panel
2-45 CL-S400DT
Operation procedure for “Service Counter/Cut Center” submenu:
1. Enter Factory/Service mode by turning on the power while pressing and holding the
[MENU], [FEED] and [STOP] keys.
“Factory Setup” main menu appears.
2. Press the [MENU] (T) or [FEED] (S) key until “Service Mode” main menu appears.
3. Press the [STOP] (X) key to enter Service mode.
4. Press the [MENU] (T) or [FEED] (S) key until a desired submenu (e.g. “Service
Counter”) appears.
5. Press the [STOP] (X) key to select “Service Counter” submenu.
Then, the service counter length since the service counter is reset last is displayed.
* To reset the service counter, proceed to the next step. Otherwise, proceed to Step 7.
6. Resetting the service counter:
1) Press the [STOP] (X) key.
2) Press the [MENU] (T) or [FEED] (S) key and select “Yes”.
3) Press the [STOP] (X) key to perform resetting.
7. Press the [PAUSE] (W) key to return to “Service Mode” main menu.
8. To check other submenu, repeat from Step 3. Otherwise, turn off the power to
terminate Factory/Service mode.
Service Mode
Service Counter
S
T
Length
0123.456 km
Reset?
No
S
T
Reset?
Yes
S
T