Citizen CL-S400DT - SA Adjust Sensor L

Chapter 3 Disassembly and Maintenance
3-6 Disassembly, Reassembly and Lubrication
3-17 CL-S400DT
3-6-9. SA Adjust Sensor L
1. Remove the “SA Cover”. Refer to “3-6-2 SA Cover and SA LCD PCB”.
2. Remove the “Case” from the main body. Refer to “
3-6-3 Case”.
3. Disconnect the “SA Mechanism Frame” from the “SA2 Base Frame”. Refer to “
3-6-4
Disconnecting “SA Mechanism Frame” from “SA2 Base Frame””.
4. Disassemble the “SA Mechanism Frame”. Refer to “
3-6-7 Disassembly of “SA Mechanism
Frame””.
5. Removal of the “SA Guide Paper L”():
1) Remove 2 screws (BH (N), M3x6 (NI))().
2) Unhook the claws (rear side: 5 place, left side: 1 place) of the “SA Guide Paper L”() and
remove the “SA Guide Paper L” upward after sliding it to the right.
6. Removal of the “SA Head Up SW”():
1) Remove 1 screw (BHT (PT), M3x6) and detach the “Holder Cover Open SW”().
2) Remove 1 screw (NO.0, PHT (BT #3), M1.7x7) and detach the “SA Head Up SW”().
Spring Leaf Guide
Paper R
Holder Cover Open SW
Guide Paper L
SA Head Up SW
Guide Paper R
BH (N), M3x6
(NI)
Sheet Adjust
Sensor L Scale
Key Adjust Sensor L
Spring Adjust Sensor L
Sheet Adjust Sensor L
SA Adjust Sensor L
Holder Adjust Sensor L Cable
Holder Adjust Sensor L
Lever Adjust Sensor L
NO.0 PHT (BT #3), M1.7x7
BHT (PT),
M2x5
BHT (PT), M3x6
SA2 Main Frame
NO.0 PHT (BT#1), M2x3
SA Guide Paper L
Label, Edge
Caution-02
3
4
14
5
12
13
11
9
10
6
7
15
1
8
2
NO.0, PHT (PT, BK), M2x5