Chapter 3 Disassembly and Maintenance
3-6 Disassembly, Reassembly and Lubrication
CL-S400DT 3-22
"Holder Adjust Sensor U" is fully moved to the right.
Guide Paper U
Cover Adjust Sensor U
Hole (for boss)
Top View
Hook
"Holder Adjust Sensor U" is fully
moved to the left.
Hole (for boss)
Ends
Cable of the "SA Adjust Sensor U".
Pawl Adjust Sensor U
Holder Adjust Sensor U
Protrusion
Protrusion
Notes on reassembling:
• As shown in the above enlarged view, pass the wires of the “Holder Adjust Sensor U” through
the slits and fix them with the hook. Be sure that they do not run over the hook.
• Engage the “Pawl Adjust Sensor U” with the “Holder Adjust Sensor U” so that the protrusions of
the “Pawl Adjust Sensor U” come upper side.
• When assembling the “Cover Adjust Sensor U”, first insert its 2 ends into the “Guide Paper U”.
Next, position it by aligning its 2 holes with the bosses, and then fix it with 2 screws. (Refer to the
following figure.)
• Hook the cable of the “SA Adjust Sensor U” at 2 places as shown below. In this case, hook the
cable so that it slacks a little when the “Holder Adjust Sensor U” (blue knob) is fully moved to the
right. In this condition, be sure that the cable is not tightened.
Meanwhile, when the “Holder Adjust Sensor U” (blue knob) is fully moved to the left, the cable
will make a round shape shown in the enlarged view.
• After assembling the “SA Adjust Sensor U”, stick
the “Sheet Adjust Sensor U”.
First, move the “Holder Adjust Sensor U” in the
direction of the arrow until it stops. Next, position
the “Sheet Adjust Sensor U” so that its scale
marking “0” is aligned with the arrow head of the
“Holder Adjust Sensor U”, and then stick it.
Holder Adjust Sensor U
Sheet Adjust Sensor U
To Next Page
Loading...
