Citizen CT-S2000 - Black Mark Control Commands; GS FF (Valid Only at B.M Model) (Printing and Ejecting Black Mark Paper); GS < (Valid Only at B.M Model) (Initializing the Printer Mechanism)

- 101 -
2.2.13 Black Mark Control Commands
GS FF (Valid Only at B.M Model)  
[Function] Printing and ejecting Black mark paper
[Code] <1DH><0C>H
[Outline] This command prints the data in the printer buffer and ejects Black mark paper.
[Caution] Valid only if Black mark paper is selected.
[See Also] FF, GS <
GS < (Valid Only at B.M Model)  
[Function] Initializing the printer mechanism
[Code] <1D>H<3C>H
[Outline] Performs initializing operation at Black mark similar to the initialization at power on.
[Caution] • This command is valid only when B.M paper is chosen.
• Parameters configured by commands are not reset.