Citizen CT-S2000 - Msw3

- 182 -
• MSW2-6󳊛 Reserved [Fixed to OFF (0)]
• MSW2-7󳊛 Reserved [Fixed to OFF (0)]
• MSW2-8󳊛 PNE sensor
[Outline] Select paper near-end enable/disable.
OFF (0) ON (1)
PNE Sensor Valid Invalid
ON (1) OPERATION: Disable paper near-end
OFF (0) OPERATION: Enable paper near-end
[Default] OFF (0) [Valid]
MSW3
• MSW3-1󳊛 Auto-cutter return
[Outline] Select return method from cutter lock error.
OFF (0) ON (1)
Resum Cttr Err Valid Invalid
ON (1) OPERATION: Return by command.
After removing error cause, return with command <DLE ENQ n>.
OFF (0) OPERATION: Return with FEED switch.
After removing error cause, return by long pressing FEED SW (1 sec or longer).
[Default] OFF (0) [Valid]
• MSW3-2󳊛 Reserved [Fixed to OFF (0)]
• MSW3-3󳊛 Parallel 31 pin
[Outline] Printer can be reset by parallel I/F –31 Pin signal. Select the handling of this signal.
OFF (0) ON (1)
Parallel 31 pin Valid Invalid
ON (1) OPERATION: Used as reset signal
OFF (0) OPERATION: Not used as reset signal
[Default] OFF (0) [Valid]
* Parallel I/F specification only enabled.
• MSW3-4󳊛 Reserved [Fixed to OFF (0)]
• MSW3-5󳊛 Reserved [Fixed to OFF (0)]
• MSW3-6󳊛 Reserved [Fixed to OFF (0)]