Citizen CT-S2000 - Status Commands; Paper Detecting Commands; Macro Commands

- 7 -
󳌤
Line Feed Span Commands
Command Function MODE GS P
ESC 2 Specifying 1/6-inch line feed rate S.P.
ESC 3 Setting line feed rate of minimum pitch S.P.
󳥫
󳌤
Bit Image Commands
Commands Function MODE GS P
ESC * Specifying the bit image mode S.P.
GS * Defining the download bit image S.P.
GS / Printing the downloaded bit image S.P.
GS v 0 Printing of raster bit image S
󳌤
Status Commands
Command Function MODE GS P
DLE EOT Sending status in real-time S.P.
ESC u
Transmitting the status of peripheral equipment
(Serial Mode Only)
S.P.
ESC v Sending Printer status S.P.
GS a Enabling/disabling ASB (Automatic Status Back) S.P.
GS r Sending status S.P.
Paper Detecting Commands
Command Function MODE GS P
ESC c 3 Selecting the Paper Sensor valid for Paper-end signal output S.P.
ESC c 4 Selecting the Paper Near-end Sensor valid for print stop S.P.
󳌤
Panel Switch Commands
Command Function MODE GS P
ESC c 5 Enabling/disabling the panel switches S.P.
󳌤
Macro Commands
Command Function MODE GS P
GS : Starting/ending macro definition S.P.
GS ^ Executing the macro S.P.
󳌤
Cutter Commands
Command Function MODE GS P
ESC i Full cut
ESC m Partial cut
GS V Cutting the paper S.P.
󳥫
󳌤
Bar Code Commands
Command Function MODE GS P
GS H Selecting of printing position of HRI characters S.P.
GS f Selecting the font of HRI characters S.P.
GS h Specifying the height of the bar code S.P.
GS k Printing the bar code S.P.
GS w Specifying the horizontal size (magnification) of bar code S.P.
󳌤