- 62 -
GS r n
[Function] Sending status
[Code] <1D>H<72>H<n>
[Range] 1≤n≤2
49≤n≤50
[Outline] Sends the specified status to the host.
n Function
1, 49 Sends the Paper Sensor status.
2, 50 Sends the Drawer Kick-out Connector status.
[Caution] • When the serial interface is used:
For DTR/DSR control:
The printer sends the status after verifying that the host is ready to receive. If the
host is not ready to receive, the printer waits for the host to become ready to
receive.
For XON/XOFF control:
The printer sends the status without checking whether the host is ready to receive
or busy.
• Because this command is executed when data is mapped in the receive buffer, there
may be a delay between receiving the command and sending the status depending
on the condition of the receive buffer.
• If ASB (Automatic Status Back) is enabled by GS a, the host must discriminate
between the status due to this command and the status due to ASB.
• Paper Sensor status (n = 1, 49)
Bit Status Hex. Decimal
Paper found by Paper Near-end Sensor 00 0
0, 1
Paper not found by Paper Near-end Sensor 03 3
Paper found by Paper-end Sensor 00 0
2, 3
Paper not found by Paper-end Sensor (0C) (12)
4 Unused 00 0
5 Undefined — —
6 Undefined — —
7 Unused 00 0
Bits 2, 3: Whenever the Paper-end Sensor detects a “paper out” state, the printer goes
offline, and the command is not executed. Therefore, the printer never sends
a status “No paper in Paper-end detector (0CH)”.
To Next Page
Loading...
