Citizen CT-S2000 - ESC a N (Aligning the Characters)

- 39 -
ESC a n 
[Function] Aligning the characters
[Code] <1B>H<61>H<n>
[Range] 0≤n≤2
48≤n≤50
[Outline] All the printed data within one line are aligned in the specified position.
Depending on the value “n”, positional alignment is carried out as shown in the table
below:
n Position
0, 48 Left end alignment
1, 49 Centering
2, 50 Right end alignment
[Caution] • This command is valid only when it is inputted at the beginning of a line.
• This command does not affect the PAGE MODE.
• Executes justification in the print area being set.
[Default] n = 0
[Sample Program]
LPRINT CHR$(&H1B);"a"; CHR$(0);
LPRINT "AAAAA"; CHR$(&HA);
LPRINT CHR$(&H1B);"a"; CHR$(1);
LPRINT "AAAAA"; CHR$(&HA);
LPRINT CHR$(&H1B);"a"; CHR$(2);
LPRINT "AAAAA"; CHR$(&HA);
[Print Results]
AAAAA
AAAAA Paper feed direction
AAAAA
Left-justified Centered Right-justified