Citizen CT-S2000 - Msw2

- 180 -
• MSW1-6󳊛 Reserved [Fixed to OFF (0)]
• MSW1-7󳊛 DSR signal
[Outline] Printer can be reset with DSR (serial I/F-6pin) signal. Select enable/disable of reset function with
this signal.
OFF (0) ON (1)
DSR Signal Invalid Valid
ON (1) OPERATION: Used as reset signal
OFF (0) OPERATION: Not used as reset signal
[Default] OFF (0) [Invalid]
* Serial I/F specification only enabled.
• MSW1-8󳊛 INIT signal
[Outline] Printer can be reset with INIT (serial I/F-25Pin) signal. Select enable/disable of reset function
with this signal.
OFF (0) ON (1)
INIT Signal Invalid Valid
ON (1) OPERATION: Used as reset signal
OFF (0) OPERATION: Not used as reset signal
[Default] OFF (0) [Invalid]
* Serial I/F specification only enabled.
MSW2
• MSW2-1󳊛 Reserved [Fixed to ON(1)]
• MSW2-2󳊛 Auto-cutter operation
[Outline] Select auto-cutter enable/disable.
󲨘
OFF (0) ON (1)
Auto Cutter Invalid Valid
ON (1) OPERATION: Auto-cutter enabled
OFF (0) OPERATION: Auto-cutter disabled
[Default] ON (1) [Valid]