- 179 -
• MSW1-3: Busy condition
[Outline] Select the condition that printer is BUSY. Automatic status send function also runs.
OFF (0) ON (1)
Busy Condition Buffer full/Off-line Buffer full
ON (1) OPERATION: If receive buffer is full, printer is BUSY.
Automatic status send ASB function is enabled.
OFF (0) OPERATION: If receive buffer is full or off-line, printer is BUSY.
Automatic status send ASB function is disabled.
[Additional Description]
Even if ON is selected, printer enters BUSY status when power is turned on or reset by
I/F or at self test print.
Printer Status
MSW1-3
OFF
MSW1-3
ON
Power-up or reset used by I/F ● ●
Self-print ● ●
Cover open ● ―
Paper-feed by FEED SW ● ―
Paper-end (including print stop in PNE) ● ―
Error generation ● ―
Off-line
Waiting during macro run by FEED SW ● ―
Buffer full Receive buffer full ● ●
[Default] OFF (0) [Buffer full/off-line]
• MSW1-4 Receive error character
[Outline] Select handling of data detected where the serial communication detects the receive data framing
error, overrun error and parity error.
OFF (0) ON (1)
Receive Error Print ? No Print
ON (1) OPERATION: Not printed as “?”
OFF (0) OPERATION: Printed as “?”
[Default] OFF (0) [Print ?]
• MSW1-5 CR code
[Outline] Select the printer when receiving CR(<0D>H) code.
OFF (0) ON (1)
CR mode Ignored LF
ON (1) OPERATION:
Select the same operation with LF when receiving CD code.
Print data in print buffer and put linefeeds as specified.
OFF (0) OPERATION:
CR code may be ignored with no actions if receiving CR code.
[Default] OFF (0) [Ignored]
To Next Page
Loading...
