Citizen CT-S2000 - 5.3 Manual Setting of Memory Switch

- 27 -
ESC { n 
[Function] Specifying/canceling the inverted characters
[Code] <1B>H<7B>H<n>
[Range] 0≤n≤255
[Outline] Specifying/canceling inverted characters.
• “n” is valid only for the lowest bit (n0).
• Rotate data in the line by 180 degrees and print it.
• Control by the lowest bit (n0) is shown as follows:
n0 Condition
0 Canceling inverted characters.
1 Specifying inverted characters.
[Caution] • This command is valid only when it is specified at the beginning of a line.
• This command does not affect the PAGE MODE.
[Default] n = 0
[Sample Program]
LPRINT CHR$(&H1B); "{"; CHR$(0);
LPRINT "TEN"; CHR$(&HA);
LPRINT "ELEVEN"; CHR$(&HA);
LPRINT CHR$(&H1B); "{"; CHR$(1);
LPRINT "TEN"; CHR$(&HA);
LPRINT "ELEVEN"; CHR$(&HA);
[Print Results]
Inversion canceled
Paper feed direction
Inversion specified