Citizen CT-S2000 - Other Commands; DLE ENQ N (Real-Time Request to Printer)

- 137 -
2.2.15 Other Commands
DLE ENQ n 
[Function] Real-time request to printer
[Code] <10>H<05>H<n>
[Range] 0≤n≤2
[Outline] The printer responds in real-time to the request that the host specifies with number
“n”.
n Function
0
At the setting of execution of GS ^ by the FEED switch, the same processing
as that pressing the FEED switch once is carried out.
1
After recovering from an error, the printer resumes printing from the
beginning of the line where the error occurred.
2
The printer clears the receive buffer and the print buffer, and then recovers
from the error.
[Caution] • (n = 1) or (n = 2) shall be used after removing the error.
• When receiving a code row coinciding with the code configuring this command, the
same operation as this command takes place and attention by the user is required.
Example: When corresponding code row is present in bit image data.
• This command must not be used between other command code rows.
Example: This command is used in the bit image data.
• This command is ignored during transmission of block data.
[See Also] DLE EOT