Citizen CT-S2000 - ESC T N (Selecting the Character Printing Direction in; Printing Direction

- 36 -
ESC T n 
[Function] Selecting the character printing direction in PAGE MODE
[Code] <1B>H<54>H<n>
[Range] 0≤n≤3
48≤n≤51
[Outline] Selects the direction and start point of character printing in PAGE MODE.
n Printing Direction Start Point
0, 48 Left to right Top left (“A” in the figure)
1, 49 Bottom to top Bottom left (“B” in the figure)
2, 50 Right to left Bottom right (“C” in the figure)
3, 51 Top to bottom Top right (“D” in the figure)
Paper feed direction
[Caution] • When STANDARD MODE is selected, this command only executes the internal
flagging of the printer without affecting the printing in STANDARD MODE.
• The character mapping position will be the start point of the print area specified by
ESC W.
• The basic calculation pitch (x or y) used by the following commands varies with the
start point.
(1) If the start point is the top left or bottom right (The characters are mapped in the
direction perpendicular to the paper feed),
• Commands using x: ESC SP, ESC S, ESC
＼
• Commands using y: ESC 3, ESC J, GS $, GS
＼
(2) If the start point is the top right or bottom left (The characters are mapped in the
paper feed direction),
• Commands using x: ESC 3, ESC J, GS $, GS
＼
• Commands using y: ESC SP, ESC S, ESC
＼
[Default] n = 0
[See Also] Appendix 4.1 “Explanation on PAGE MODE”
ESC $, ESC L, ESC W, ESC
＼ , GS $, GS P, GS ＼