- 10 -
2.2 Command Details
2.2.1 Print Control Commands
LF
[Function] Printing and paper feed
[Code] <0A>H
[Outline] Prints data inside the print buffer and feeds paper based on the line feed amount
having been set.
[Caution] After this command is executed, the beginning of the line is taken as the start position
for the next point.
[See Also] ESC 2, ESC 3
[Sample Program]
LPRINT "AAA"; CHR$(&HA);
LPRINT "BBB"; CHR$(&HA); CHR$(&HA);
LPRINT "CCC"; CHR$(&HA);
[Print Results]
AAA Print and line feed
BBB Print and line feed
Line feed only
CCC Print and line feed
CR
[Function] Back to printing
[Code] <0D>H
[Outline] (1) When memory switch 1-5 is OFF:
This command is ignored.
(2) When memory switch 1-5 is ON:
The same operation as LF is executed.
[See Also] LF
[Sample Program]
LPRINT "AAA"; CHR$(&HD);
LPRINT "BBB"; CHR$(&HD);
LPRINT CHR$(&HD);
LPRINT "CCC"; CHR$(&HD);
[Print Results]
In case of (2)
AAA Print and line feed
BBB Print and line feed
Line feed only
CCC Print and line feed