Citizen CT-S2000 - ESC P M N1 N2 (Generating the Specified Pulses)

- 145 -
ESC p m n1 n2 
[Function] Generating the specified pulses
[Code] <1B>H<70>H<m><n1><n2>
[Range] m = 0, 1, 48, 49
0 <n1≤n2≤255
[Outline] • The signals specified by “n1” and “n2” are output to the connector pin specified by
“m”.
• “m” has the followings.
m Connector Pin
0, 48 Drawer kick-out pin No. 2
1, 49 Drawer kick-out pin No. 5
• The ON time is n1 x2 ms, and OFF time n2 x2 ms.
[Caution] • When “m” is beyond a definition range, no signal is output, discarding “n1” and “n2”.
• The drawer drive duty must be within the following range:
ON time 
ON time + OFF time
(The OFF time should be 4 times or more longer than the ON time.)
[Sample Program]
LPRINT CHR$(&H1B) + "p"
LPRINT CHR$(0); ←Selects pin No. 2.
LPRINT CHR$(5); ←Sets ON time to 10 ms
LPRINT CHR$(50); ←Sets OFF time to 100 ms
≤
0.2