Citizen CT-S2000 - GS G 2 M Nl Nh (Sending Maintenance Counter)

- 97 -
GS g 2 m nL nH 
[Function] Sending maintenance counter
[Code] <1D>H<67>H<32>H<m><nL><nH>
[Range] m=0
20󳞎(nL+nH󳎺256)󳞎198
(nL=20󳪛21󳪛50󳪛70󳪛148󳪛149󳪛178󳪛198󳪛nH=0)
[Outline] Send the maintenance counter value specified.
nL, nH are used to set the maintenance counter number to (nL+nH×256).
Counter Number
Hexadecimal Decimal
Counter 󳯈Unit󳯊 Counter Type
14 20 Paper-feed line󳯈line󳯊 Resettable
15 21 Head powering count 󳯈times󳯊 Resettable
32 50 Auto-cutter drive count 󳯈times󳯊 Resettable
46 70 Product operation time󳯈hours󳯊 Resettable
94 148 Paper-feed line󳯈line󳯊 Accumulated
95 149 Head powering count 󳯈times󳯊 Accumulated
B2 178 Auto-cutter drive count 󳯈times󳯊 Accumulated
C6 198 Product operation time󳯈hours󳯊 Accumulated
• Configuration of data to be sent is shown below for the maintenance counter.
Hexadecimal Decimal Data Count
Header 5FH 95 1 byte
Data 30H ∼ 39H 48 ∼ 57 1 - 10 bytes
NUL 00H 0 1 byte
[Caution] • During sending block data (maintenance counter value), real-time status and ASB
status shall not be sent. Thus, during sending the data, printer status can not be
notified.
• Counter value sent by this command is only a guideline value. Due to an error
occurrence and power off timing, figure data may have an error.