134
ENGINE
CHECKING AND SETTING THE VALVE TIMING
Engine: 3FZ
Refitting.
IMPERATIVE: Check that the tensioner roller, guide roller and coolant pump can turn freely
(without play and without tight spots); check also that these rollers are not noisy and/or
that they are not splashed with grease.
If replacing the tensioner roller (15): Tighten to 3,5.
Turn the tensioner roller, using tool [5a], to go past the slot «c».
Position the tool [5b] to lock the index «b» and remove the tool [5a].
IMPERATIVE: Systematically replace the following components: Timing belt, exhaust
manifold fixing nuts, timing belt tensioner roller nut.
Reposition the timing belt on the crankshaft pinion.
Hold the timing belt in place using tool [3].
B1EP1BRC
B1EP1BQD
C8
Angl.T3-page032-190-2005 4/02/05 15:15 Page 134
To Next Page
Loading...
