135
ENGINE
CHECKING AND SETTING THE VALVE TIMING
Engine: 3FZ
Fit the timing belt in place, respecting the following order:
- Guide roller (15).
- Inlet camshaft pulley (14).
- Exhaust camshaft pulley (13).
- Coolant pump (10).
- Tensioner roller (11).
NOTE: Make so that the belt is as flush as possible with the exterior face of the various pinions
and rollers.
Remove:
- Tool [3].
- Tool [1] from the exhaust camshaft pulley.
- Tool [5b] from the tensioner roller.
Refit:
- The lower timing cover (9).
- The crankshaft pulley (16).
- The screw (8) of the crankshaft pulley.
- Tighten screw (8) to 4 ± 0,4 m.daN, then angular tighten to 53° ± 4°, tool [4].
B1EP1BPD
B1EP1BRC
C8
Angl.T3-page032-190-2005 4/02/05 15:15 Page 135
To Next Page
Loading...
