Clark GEX20 - Disassembly and Reassembly of Axle End

Group 20, Drive Axle
SM 765, Nov ’06 Disassembly and Reassembly of axle end • 20-5-1
N
O
TE
Arrange all the parts under the order of dis-
assembly.
Pay attention to the parts and removal order
when disassemble.
Record with irremovable pen if necessary
and distinguish the parts.
Removal of axle end from the drive axle
Remove hexagon socket bolts from the plate housing by
using appropriate tool to disassemble the wheel assembly
and drive axle.
Disassembly of carrier and hub bear-
ing
Plant gear shaft
Pin spring
Taper roller bearing
Spacer
Housing final
Bearing taper
Oil seal
Bolt stud
Adaptor
Bolt
Wheel cap
O-ring
Lock nut
Lock nut
Lock washer
Spacer
Washer
Washer
Planetary gear
Needle bearing
Section 5
Disassembly and Reassembly of axle end