Group 23, Brake System
23-6-2 • Parking Brake Service SM 765, Sep ’06
Parking Brake Cable Removal and
Installation
1. Disconnect each parking brake cable from the ratchet
assembly as shown in the illustration below.
2. Remove the parking cable from the service brake
assembly by first removing the brake shoes as
described in the “Brake Overhaul and Adjustment”
Section of this Group.
3. Pull out the C-clip that holds the parking brake cable
to the backing plate.
4. Unhook the parking brake cable end from the lever
on the shoe and pull the cable from the assembly.
5. Installation is the reverse of removal.
Pin
Lock Nut
To Next Page
Loading...
