Group 23, Brake System
23-3-2 • Brake Pedal Linkage & Adjustments SM 765, Nov ’06
Introduction
The illustration shows the service brake linkage which
links the brake pedal to the master cylinder.
Adjustment
Adjust the master cylinder push rod assembly to eliminate
any slack in the pedal linkage. Adjust only the minimum
required to remove pedal play.
If you want to adjust the height of brake pedal, adjust the
height as 25mm by use of stop bolts of brake pedal and
then lock the nuts.
Tighten the stop bolts and nuts with torque of 20-
25N.m(14-18 ft.lb).
Jam Nut &
Push Rod Assembly
Master Cylinder
Brake Reservoir
Return Spring
Stop Bolt
Brake Lever &
Pedal
Brake Line to
Master Cylinder
To Next Page
Loading...
