User Guide| FreeSpeak II for Eclipse HX
Use the left-hand rotary control to select the required channel, or select M for the master volume
Use the right-hand rotary control to adjust the volume level. The default is 0dB for channel audio,
and -9.6dB for master volume.
The volume level appears in the footer.
To confirm the selection, press the Menu Select key (D).
5.2.2 Configuring the volume level of the line input
You can configure the volume of an audio line input:
1. To enter the beltpack menu, press and hold the Menu key.
2. Turn either rotary control clockwise to highlight Line In Vol Lvl, and press the Menu Select key
(D).
3. Use either rotary control to select between -15 dB to 6dB
4. To confirm the selection and exit the menu screen, press the Menu Select key (D).
5.2.3 Configuring the rotary controls
You can configure the rotary controls on the beltpack to either:
l Control the volume of the audio on keys A and B
l Control the master volume of the beltpack audio.
1. To enter the beltpack menu, press and hold the Menu key.
2. Turn either rotary control clockwise to highlight Vol Operation, and press the Menu Select key
(D).
3. Use either rotary control to select between:
n Talk Key
n Master
4. To confirm the selection and exit the menu screen, press the Menu Select key.
5.3 Configuring the beltpack headset
You can configure the following headset settings:
l Headset autodetect
l Headset sidetone level
l Headset limiter
Page 37
To Next Page
Loading...
Need help?
General
