User Guide| FreeSpeak II for Eclipse HX
5 Programming on the beltpack
This chapter explains how to program the beltpack using the beltpack's menu system. It contains
the following sections:
l Introduction to programming on the beltpack on page 35
l Configuring the beltpack volume settings on page 36
l Configuring the beltpack headset on page 37
l Configuring the beltpack microphone on page 38
l Configuring the beltpack display and LEDs on page 39
l Configuring the beltpack alarm options on page 41
l Selecting the beltpack role default set on page 43
l Selecting the beltpack administration on page 43
l Setting the listen again option on page 44
l Accessing beltpack information on page 45
l Setting display mode on page 46
l Setting system connect on page 46
l Enabling over the air (OTA) registration mode from a beltpack on page 46
l Performing a site survey on page 48
5.1 Introduction to programming on the beltpack
You can access the beltpack menu by pressing and holding the menu key. The Master Menu
screen is displayed. This consists of the following submenus:
l Volume Level Control
l Volume Operation
l Line In Volume Level
l Settings
l Information
l Display Mode
l System Connect
Page 35
To Next Page
Loading...
