User Guide| FreeSpeak II for Eclipse HX
3.3 Adding the E-Que card for an FS II transceiver or splitter to the
matrix
Note: You can only use the FS II splitter with FS II transceivers that connect to an E-Que card. You
cannot use the splitter with the FreeSpeak II IP Transceiver.
The E-Que card is designed to allow Eclipse HX matrices to connect to FreeSpeak and
FreeSpeak II wireless transceivers/beltpacks or connect together using E1 or T1 protocol. You will
need an E-Que card and a rear port. You will need to make sure the E-Que card is physically
connected to the matrix and configured for communication in the Eclipse software. See 3.1.1 and
3.1.2. below.
3.3.1 Installing and removing an E-IPA-HX or E-Que card.
To install a card:
1. Carefully place the card in the appropriate slot. Make sure the card is aligned with the top and
bottom precision guides.
2. Push the card toward the backplane connectors.
3. When the card has almost reached the backplane connectors, open the two ejector tabs,
allowing them to clear the edges of the matrix. Gently insert the card further until it touches the
backplane connector guides.
4. Gently close both ejector tabs at the same time, to propel the card into the backplane
connectors.
To remove a card from the matrix
1. Hold the card in place in the matrix.
2. The two card ejector tabs are located at the top and bottom of the card. To remove a card,
open the two ejector tabs at the same time until the card unseats from its backplane
connectors.
3. Pull the card out of the matrix.
3.3.2 Adding an E-Que card to the software
To add an E-Que card to the software:
1. In the EHX configuration software, go to Hardware > Cards and Ports, and navigate to an
available slot number (marked Empty).
2. Do either of the following:
n Double click the slot.
n Right click the slot and select Set Card Type.
Page 15
To Next Page
Loading...
Need help?
General
