User Guide| FreeSpeak II for Eclipse HX
l None
l Basic
l Normal
l Advanced
If this setting is not enabled, the menu access is set in the EHX software to one of the above four
levels. When it is enabled, the beltpack has full menu access.
Note: If you change this setting, it will apply until the beltpack role changes, or the beltpack is power
cycled.
1. To enter the beltpack menu, press and hold the Menu key.
2. Use the rotary and Menu Select keys to select Settings > Admin Options. You will be
prompted to enter a four digit code. The default code is 4632.
3. Select Full Menu Access.
4. Use either rotary control to select between:
n Disable (default)
n Enable
5.8.3 Setting system sync mode (not currently available)
Use this setting to make transceiver synchronization readings.
1. To enter the beltpack menu, press and hold the Menu key.
2. Use the rotary and Menu Select keys to select Settings > Admin Options. You will be
prompted to enter a four digit code. The default code is 4632.
3. Select System Sync.
4. Use either rotary control to select the transceiver group to synchronize.
5.9 Setting the listen again option
Use this setting to configure an option to allow you to play back an incoming message. When
Listen Again is active, if you tap the Menu key on the beltpack, the last received message is played
back. You can select the length of the recorded message, and also how long the message is
stored on the beltpack before automatic deletion. To play back a recorded message, press the
Menu button.
To select the length of the recording:
Page 44
To Next Page
Loading...
Need help?
General
