User Guide| FreeSpeak II for Eclipse HX
5.7 Selecting the beltpack role default set
Use this setting to set the beltpack configuration to the default settings defined in the EHX
configuration map for that role.
1. To enter the beltpack menu, press and hold the Menu key.
2. Use the rotary and Menu Select keys to select Settings > Role Default Set.
3. Use either rotary control to select between:
n On (default)
n Off
4. To confirm the selection and exit the menu screen, press the Menu Select key (D).
5.8 Selecting the beltpack administration
You can select the following administration settings:
l System pairing mode
l Full menu access
l System sync mode
5.8.1 Enabling OTA registration mode
Use this setting to enable or disable system pairing mode. Enable this mode if you want to register
a beltpack over the air.
1. To enter the beltpack menu, press and hold the Menu key.
2. Use the rotary and Menu Select keys to select Settings > Admin Options. You will be
prompted to enter a four digit code. The default code is 4632.
3. Select Enable Pair Mode.
4. Use either rotary control to select between:
n Disable
n Enable
5. To confirm the selection and exit the menu screen, press the Menu Select key (D).
5.8.2 Setting full menu access
Use this setting to override the menu access for the beltpack role. The following menu access
levels apply:
Page 43
To Next Page
Loading...
Need help?
General
