User Guide| FreeSpeak II for Eclipse HX
Table of contents
1 Important Safety instructions 6
1.1 Safety symbols 7
2 Introduction to FreeSpeak II® 8
2.1 An FS II communication system 8
2.2 FreeSpeak II with an FSII Transceiver (1.9 and 2.4) 9
2.3 FreeSpeak II with an FSII IP Transceiver 10
2.4 FSII 1.9 GHz/FSII 2.4 GHz 11
2.5 National Radio Carrier Frequencies 12
3 Installing a system 14
3.1 Installing and removing an E-IPA-HX card 14
3.2 Adding an E-IPA-HX card to the software 14
3.3 Adding the E-Que card for an FS II transceiver or splitter to the matrix 15
3.4 Connecting to transceivers 17
3.5 Clear-Com Cable Recommendations 19
4 Operating the wireless beltpack 21
4.1 Overview of the wireless beltpack 21
4.2 Beltpack user controls 24
4.3 Using the beltpack 29
5 Programming on the beltpack 35
5.1 Introduction to programming on the beltpack 35
5.2 Configuring the beltpack volume settings 36
5.3 Configuring the beltpack headset 37
5.4 Configuring the beltpack microphone 38
5.5 Configuring the beltpack display and LEDs 39
5.6 Configuring the beltpack alarm options 41
5.7 Selecting the beltpack role default set 43
5.8 Selecting the beltpack administration 43
5.9 Setting the listen again option 44
5.10 Control audio on keys C & D (beltpack)(advanced menu option only) 45
5.11 Accessing beltpack information 45
5.12 Setting display mode 46
5.13 Setting system connect 46
5.14 Enabling over the air (OTA) registration mode from a beltpack 46
5.15 Performing a site survey 48
Page 3
To Next Page
Loading...
