User Guide| FreeSpeak II for Eclipse HX
6 Operating the FS II IP Transceiver (IPT) 49
6.1 IP rating (Protection Marking) 49
6.2 FS II IP Transceiver connector panel 50
6.3 IP Transmitter LEDs 50
6.4 IP Transceiver fans and filters 51
6.5 Reset the IPT to default 54
6.6 Transceiver standalone mode 54
6.7 Connecting the FS Transceivers to a matrix 54
6.8 Cabling the IP transceivers 58
6.9 Configuring the E-IPA-HX card for FreeSpeak II 59
6.10 Adding transceivers 60
6.11 Powering the transceiver 65
6.12 Upgrading the FS II IP Transceiver firmware 66
6.13 Upgrading from the matrix 66
6.14 Upgrading by USB connection 67
6.15 Port security settings 67
6.16 Network and synchronization 67
6.17 General network and switching rules 68
6.18 Beltpack support capacities for FS II IP Transceivers 68
6.19 Coverage areas under various conditions 69
6.20 FS II Transceiver setup rules and tips 69
6.21 Spare parts 70
7 Operating the FS II Transceiver 71
7.1 IP rating (Protection Marking) 71
7.2 FS II transceiver connector panel 71
7.3 Cabling the FS II transceivers 72
7.4 Beltpack support capacities for FS II Transceivers 77
7.5 Placing the transceivers and splitters 77
7.6 Determining coverage areas 79
7.7 Coverage areas under various conditions 80
7.8 FS II Transceiver setup rules and tips 80
7.9 Doing a site survey to determine coverage areas 81
7.10 Registering beltpacks 85
7.11 Upgrading FS II Transceiver firmware 86
7.12 Upgrading by USB connection 86
7.13 Upgrading by wireless connection 86
8 Using the FreeSpeak II Base splitter (FSII-SPL) 88
Page 4
To Next Page
Loading...
Need help?
General
