User Guide| FreeSpeak II for Eclipse HX
4 Operating the wireless beltpack
This chapter explains how to operate the FS II beltpack. It contains the following sections:
l Overview of the wireless beltpack on page 21
l Beltpack user controls on page 24
l Using the beltpack on page 29
4.1 Overview of the wireless beltpack
An FS II wireless beltpack gives you simultaneous access to up to five channels of talk/listen
communication, with the ability to switch among them as desired. Any or all of these routes may be
kept open during use. You can adjust Incoming volume levels (“listen levels”) using the two rotary
level controls, so that one conversation can be monitored in the background while a primary
conversation is held.
The panel display contains the role (label) of the beltpack user, identifies up to four talk/listen labels
currently selected, and gives other information such as signal strength and battery level. You can
choose between two display modes:
l Intercom display mode – displays key labels, role name, signal strengths, battery level
and volume levels.
Page 21
To Next Page
Loading...
Need help?
General
