Satellite profiles and modem profiles
98-148248-C Chapter 6: Configuration 6-29
6666
VLAN port membership table
The VLAN port membership table is configured by the modem as configured by the service
provider. The table is useful when troubleshooting.
6.5.5 E-mail setup
If you want to send diagnostics and statistics reports through an external Internet
connection using e-mail you must set up some parameters.
To configure the e-mail setup, do as follows:
1. Go to SETTINGS > E-mail setup.
2. Enter the data for Outgoing mail server (SMTP), SMTP port number, SMTP
authentication, User name and password. This data is typically provided by your IT
department.
3. Select the SMTP type, for secure e-mail select SMTPS or STARTTLS.
• SMTP: SMTP over port 25
• SMTPS: SMPT Secure usually uses port 465, SMTPS is 'deprecated' data between
client and server, encrypted with SSL or TLS, this is decided beforehand.
• STARTTLS can upgrade the connection to SSL or TLS, it is not dependent on a port as
SMTPS. SSL and TLS connections are encrypted, just as HTTPS, the data of the
connection cannot be (easily) read.
4. Select SMTP authentication, if needed. Credentials means that a user name and
password are needed to be allowed to use the given mail server (SMTP). This data is
typically provided by your IT department.
Figure 6-23: Web interface: SETTINGS, E-mail setup
You must set Outgoing mail server to an IP address if DNS has not been set
up in DNS setup in To configure the LAN network on page 6-26.
To Next Page
Loading...
Need help?
General