32
Options
The appearance of the Options screen varies depending on the
type of sensor, the image display mode and the operator controls
enabled during Setup Mode. In Tiled Image Mode, only the controls
that are supported by all sensors are displayed. In Single Image
Mode, the controls that are supported on the selected sensor are
displayed.
Figure 4-8: Options Screen
Log Off: If the Require User Authentication checkbox is checked in
Setup Mode (refer to Sensor Settings on page 18) and the user
attempts to perform a restricted Run Mode action, the user is
prompted to re-enter the Sensor Password. Once the user has
completed the action, the user can click the Log Off button from the
Options screen to return to restricted access mode. If the user does
not manually log off, the session will automatically timeout after the
duration of the Idle Timeout (refer to Security Settings on page 18).
Configure Custom View: Opens the Configure Custom View
screen to configure the size and position of the In-Sight Custom
View when displayed from VisionView.
Configure SmartLink Table: Opens the Configure SmartLink
Table screen to configure the size and position of the DVT
SmartLink table when displayed from VisionView.
Language: Opens the Language screen to select the language to
use in the VisionView interface.
Filmstrip
• On a Reject: Defines the behavior of the filmstrip when the
inspection fails. If the reject action is changed while in Run
Mode, the setting is only applied to the active sensor, and
will persist if VisionView is power-cycled or placed in Setup
Mode.
• Continue: If the inspection fails, the filmstrip continues
to update.
• Pause: If the inspection fails, the filmstrip pauses for
5 seconds and then continues to update.
• Freeze: If the inspection fails, the filmstrip stops
updating until the Continue button is clicked.
• Show AutoSave Failures: If the failed inspection image is
not automatically saved to the specified location, a warning
message is displayed.
Job
• Load: Allows you to load a job file to the sensor. The
available jobs only include jobs that are stored on the
Notes:
• DVT sensors only support loading a job file (or DVT
Product) to the sensor; all other Job Options are not
supported.
• The double arrow symbol (>>) next to the job name
indicates the active job file.
To Next Page
Loading...
