v
Precautions
Observe these precautions when installing VisionView to reduce the risk of injury or equipment damage:
• VisionView is intended to be supplied by a NRTL listed power supply with a minimum output rated 24VDC, 2A with a maximum short
circuit current rating of less than 8A and a maximum power rating of less than 100VA and marked Class 2 or Limited Power Source
(LPS). Any other voltage creates a risk of fire or shock and can damage VisionView components.
• To reduce the risk of damage or malfunction due to over-voltage, line noise, electrostatic discharge (ESD), power surges, or other
irregularities in the power supply, route all cables and wires away from high-voltage power sources.
• Do not install VisionView in areas directly exposed to environmental hazards such as excessive heat, dust, moisture, humidity, impact,
vibration, corrosive substances, flammable substances, or static electricity without a protective enclosure.
• Do not expose the touch screen to direct sunlight for prolonged periods of time.
• Do not place heavy, hard or sharp objects directly on or against the touch screen.
• VisionView does not contain user-serviceable parts. Do not make any electrical or mechanical modifications. Unauthorized
modifications may void your warranty.
• Changes or modifications not expressly approved by the party responsible for regulatory compliance could void the user’s authority to
operate the equipment.
• VisionView is intended for indoor use only.
• Cable shielding can be degraded or cables can be damaged or wear out more quickly if a bend radius or service loop is tighter than 10X
the cable diameter.
• Service loops should be included with all cable connections.
To Next Page
Loading...
