Conviron GEN1000 - PRECAUTIONS; Hazard Identification Symbols

July 22, 2019 | 287960-ENG | R00 1
1 PRECAUTIONS
The equipment is intended to be installed, operated, maintained, and serviced by only trained
personnel, according to the instructions and precautions described in the manuals provided by
Conviron.
Table 1-1 lists precautions intended to help guide users in the safe operation of Conviron
chambers.
1.1 Hazard Identification Symbols
Table 1-1 Hazard Identification Symbols
Symbol
Description
The ″HAZARD WARNING″ symbol is used whenever a general hazard exists which
could cause personal injury or potential equipment damage, and requires correct
procedures/practices for prevention.
The ″IMPORTANT INFORMATION″ symbol is used to identify operating procedures
which must be followed to ensure smooth and efficient equipment operation.
The ″ELECTRICAL SHOCK/ELECTROCUTION″ symbol is used to identify a
source of potentially dangerous electrical current.
The ″BURN HAZARD/HOT SURFACE″ symbol is used to identify surfaces which
are hot enough to cause personal injury.
The ″SLIP HAZARD″ symbol is used to identify a potential hazard of falling from
elevated surfaces.
The ″PROTECTIVE EARTH-GROUND″ symbol is used to identify the protective
earth connection.
The ″OPTICAL RADIATION″ symbol is used to identify areas where exposure to
ultraviolet (UV) and infrared radiation may be possible.
The ″DISCONNECT MAINS POWER″ symbol is used remind service personnel to
disconnect the power at the mains panel before servicing this equipment.