Maintenance
July 22, 2019 | 287960-ENG | R00 51
5. Replace the USH box lid and secure it in place with the hook and loop side straps.
This is very important to prevent water from splashing over electrical components.
6. Replace the USH box in the chamber by reversing the removal steps above.
6.6 Calibrate the Temperature and Humidity Sensor
Calibrate the temperature and humidity sensors yearly. Contact Conviron Service for more
information.
6.7 Adjust the Door
Refer to the Conviron Chambers Maintenance & Troubleshooting Manual for more information.
The door may be removed from the chamber if absolutely necessary. Contact Conviron for door
removal instructions.
6.8 Clean the Condensate Pump and Condensate Pan
Clean the optional condensate pump and condensate pan regularly.
To clean the condensate pump and pan:
1. Unplug the pump and slide the condensate pump and pan out from under the front of
the chamber.
2. Clean the pan and pump with a diluted vinegar solution.
3. Reinsert the pump into the pan and slide them back under the chamber.
4. Plug the pump back into the receptacle on the rear of the chamber.
The ceramic disc is very fragile; handle it with care during installation.
Operation of the door, at the hinge point, presents a crush hazard.
Warning: Electrical shock hazard during maintenance or service.
Serious personal injury or death could result from contacting live electrical circuits.
Disconnect power to the pump at the rear of the chamber before performing
To Next Page
Loading...
