Cornelius pbd175 - Safety Precautions and Handling Procedures; General Safety, Shipping, Storage, and CO2 Warnings; Decommissioning and Unit Transport

PBD175 (Spire 3.0) Service Manual
Publication Number: 620062609SER - 2 - © 2015-2016, Cornelius Inc.
SAFETY PRECAUTIONS
This unit has been specifically designed to provide protection against personal injury. To ensure continued protection
observe the following:
!
WARNING:
Disconnect power to the unit before servicing following all lock out/tag out procedures established by the user. Verify
all of the power is off to the unit before any work is performed.
Failure to disconnect the power could result in serious injury, death or equipment damage.
CAUTION:
!
Always be sure to keep area around the unit clean and free of clutter. Failure to keep this area clean may result in
injury or equipment damage.
SHIPPING AND STORAGE
CAUTION:
!
Before shipping, storing, or relocating the unit, the unit must be sanitized and all sanitizing solution must be drained
from the system. A freezing ambient environment will cause residual sanitizing solution or water remaining inside the
unit to freeze resulting in damage to internal components.
CO2 (CARBON DIOXIDE) WARNING
!
DANGER:
CO2 displaces oxygen. Strict attention MUST be observed in the prevention of CO2 gas leaks in the entire CO2 and
soft drink system. If a CO
2 gas leak is suspected, particularly in a small area, IMMEDIATELY ventilate the
contaminated area before attempting to repair the leak. Personnel exposed to high concentrations of CO
2 gas
experience tremors which are followed rapidly by loss of consciousness and DEATH.
PEPSI PBD175 (SPIRE 3.0) USAGE
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabil-
ities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
CAUTION:
!
Children should be supervised to ensure that they do not play with the appliance.
DECOMMISSIONING AND/OR TRANSPORTING THE UNIT
Whenever the unit is going to be removed from service and/or transported, the unit must be sanitized and completely
drained of all liquid.
CAUTION:
!
When transporting the unit it must be carefully tied down or stored in such a manner that the unit will not move during
shipment.