PBD175 (Spire 3.0) Service Manual
© 2015-2016, Cornelius Inc. - 45 - Publication Number: 620062609SER
Figure 91.
ICE MAKER MOUNTING
NOTE: For proper ice maker and dispenser function, it is necessary to make sure that following are
checked.
• Ice level sensor (bin stat) is installed at least 2” below hopper top (Refer to Ice maker Installation
manual).
• Ice bridge thickness is adjusted per Ice Maker manufacturer’s specification (Refer to Ice maker
Installation manual).
• Agitator board off-cycle timer settings are set properly for ice type (See "Off-Cycle Agitator Settings"
on page 44).
• Ice flow from dispenser ice chute is sufficient for ice type (See "Ice Chute Restrictor Adjustment" on
page 44).
1. Make sure top of unit is clean and free of dirt, grime, and debris.
2. Loosely mount ice maker bracket to back of
dispenser with (3) ¼-20 bolts.
Figure 92.
To Next Page
Loading...
