Setup Setup Checklist
CubiScan 125 22
3. Has the height sensor cable been connected to the sensor?
(page 9)
4. Has all shipping material been removed? (page 12)
5. Is the CubiScan 125’s scale platform free moving? The CubiScan
125 should not be pushed up against a wall and no object, cable,
etc., should be resting on it or against it.
6. Has the Ethernet, RS-232, or USB cable been attached to the
CubiScan 125 and the computer (if applicable)? (page 15)
7. Has the AC power cord been connected correctly? (page 14)
8. If you are using Qbit to operate the CubiScan 125, has the
software been copied onto your computer's hard-disk drive? (Refer
to the Qbit User Guide for information.)
9. Does the CubiScan 125 require recalibration? The CubiScan 125
was calibrated at the factory, but may require recalibration due to
handling during shipping. Refer to page 40 for information on
calibrating the CubiScan 125. If you are using Qbit software, check
the status of the CubiScan 125 before operating it. Refer to the Qbit
User Guide for information on checking the CubiScan 125’s status.
To Next Page
Loading...
