4 Web-based Switch Configuration D-Link Smart Managed Switch User Manual
102
Both – Specifies the control is exerted over both incoming and outgoing traffic through the controlled
port selected in the first field.
In – Disables the support in the present firmware release.
Click the Apply button to implement changes made.
AAA > 802.1X > 802.1X User
The 802.1X User page allows user to set different local users on the Switch. Enter a 802.1X User name,
Password and Confirm Password. Properly configured local users will be displayed in the table.
Figure 4.130 - AAA > 802.1X > 802.1X User
Click Add to add a new 802.1X user.
AAA > 802.1X > 802.1X Guest VLAN
The 802.1X Guest VLAN assigns the port which failed to authenticate via 802.1x into Guest VLAN group.
User can specify the port(s) to turn on 802.1X guest VLAN in this page.
Figure 4.131 - AAA > 802.1X > 802.1X User
Click Add to turn on 802.1x guest VLAN feature in specific port(s).
ACL > ACL Wizard
Access Control List (ACL) allows user to establish criteria to determine whether or not the Switch will forward
packets based on the information contained in each packet's header. This criteria can be specified on a
basis of the MAC address, or IP address.
The ACL Configuration Wizard will aid with the creation of access profiles and ACL Rules. The ACL Wizard
will create the access rule and profile automatically. The maximum usable profiles are 50 and with 200 Rules
in total for the switch.
To create a new access rule, select Create and enter the Access-List Name then click Next button.
To Next Page
Loading...
