D-Link DGS-1210 Series - Show Route; Config Account Admin Password

6 Command Line Interface D-Link Smart Managed Switch User Manual
1
1
5
5
7
7
System firmware version : 6.20.005
System boot version : 1.00.010
System serial number : TM0J104000507
MAC Address : 00-56-12-34-56-78
DGS-1210-28MP>
show route
Purpose To display the routing status of IPv4 or IPv6 on the Switch.
Syntax show route {ipv4 | ipv6}
Description
The show route command displays the routing status of IPv4 or
IPv6 on the Switch.
Parameters None.
Restrictions None.
Example usage:
To display the IPv4 & IPv6 route status on the Switch:
DGS-1210-52MP> show route ipv4
IPv4 Static Route State : Disable
DGS-1210-52MP> show route ipv6
IPv6 Static Route State : Disable
DGS-1210-52MP>
config account admin password
Purpose To display the configuration of an IP interface on the Switch.
Syntax config account admin password <passwd>
Description The config account admin password command
sets the
administrator password.
Parameters <passwd> − The new password of the administrator.
Restrictions None.
Example usage:
To configure the account admin password:
DGS-1210-52MP> config account admin password 1234