4 Web-based Switch Configuration D-Link Smart Managed Switch User Manual
4
4
9
9
Figure 4.45 – System > D-Link Discover Protocol Settings
D-Link Discover Protocol State: Enable or disable the Discover Protocol state. The default value is
enabled.
D-Link Discover Protocol Report Timer (Seconds): Configure the report timer of D-Link Discover Protocol
in seconds. The values are 30, 60, 90, 120 or Never.
Click the Apply button to implement changes made.
DDP Port Setting:
From Port / To Port: Specifies the range of ports to be configured for D-Link Discover Protocol of the Switch.
State: Specifies to enable or disable the D-Link Discover Protocol state for the specified ports.
Click Apply to implement changes made.
System > Firmware Information
The Firmware Information page displays the information of firmware. User is able to select the image ID for
next system boot up.
Figure 4.46 – System > Firmware Information
To Next Page
Loading...
