D-Link DGS-1210 Series - System > Dhcpv6 Relay Settings; System > System Log Configuration > System Log Settings

4 Web-based Switch Configuration D-Link Smart Managed Switch User Manual
4
4
5
5
DHCP Local Relay Status: Globally Enable/Disable DHCP Local Relay function by selecting from drop-
down list. The default value is Disabled.
Config VLAN by: Configure the VLAN by VID or VLAN Name of drop-down menu.
State: Specifies whether DHCP Local Relay is enabled on the VLAN.
Enabled – Enables DHCP Local Relay on the VLAN.
Disabled – Disables DHCP Local Relay on the VLAN.
DHCP Local Relay VID List: Displays the list of VLANs on which DHCP Local Relay has been defined.
Click the Apply button to implement changes made.
System > DHCPv6 Relay Settings
The DHCPv6 Relay Settings page allows user to configure the DHCPv6 settings.
Figure 4.39 - System > DHCPv6 Relay Settings
DHCPv6 Relay Status: Globally Enable/Disable DHCPv6 Relay function by selecting from drop-down list.
The default value is Disabled.
DHCPv6 Relay Hops Count Limit (1-32): The field allows and entry between 1 and 32 to define the
maximum number of router hops DHCPv6 messages can be forwarded. The default hop count is 4.
DHCPv6 Relay Option37 State: Specifies the DHCPv6 Relay Option37 State to be enabled or disabled.
DHCPv6 Relay Option37 Check: Specifies the DHCPv6 Relay Option37 Check to be enabled or disabled.
DHCPv6 Relay Option37 Remote ID Type: Specifies the DHCPv6 Relay Option37 Remote ID type is CID
with User Defined, User Defined or Default.
Interface: Permanently Fixed as System.
Server IP: Enter the server IP address.
Click the Apply button to implement changes made.
System > System Log Configuration > System Log Settings
This page allow user to configure event logging feature. The log messages can stored in non-volatile RAM in
various methods.