6 Command Line Interface D-Link Smart Managed Switch User Manual
152
Restrictions None.
Example usage:
To configure the IPv6 interface System:
DGS-1210-52MP> config ipif System ipv6 ipv6address 3ffe:501:ffff:100::1/64
Success.
DGS-1210-52MP>
Purpose To log out a user from the Switch’s console.
Syntax logout
Description The logout command terminates the current user’s session on
the Switch’s console.
Parameters None.
Restrictions None.
Example usage:
To terminate the current user’s console session:
DGS-1210-52MP> logout
NOTE: Save your configuration changes before
logging out.
Purpose To test the connectivity between network devices.
Syntax ping <ip_addr>
Description The ping command checks if another IP address is reachable on
the network. You can ping the IP address connected to through
the managed VLAN (VLAN 1 by default), as long as there is a
physical path between the switch and the target IP equipment. By
default, Switch sends five pings to the target IP.
Parameters <ip_addr> − The IPv4 address of the host.
Restrictions None.
Example usage:
To ping the IP address 10.90.90.91:
DGS-1210-52MP> ping 10.90.90.91
Reply Received From :10.90.90.91, TimeTaken : 20 msecs
Reply Received From :10.90.90.91, TimeTaken : 20 msecs
Reply Received From :10.90.90.91, TimeTaken : 20 msecs
To Next Page
Loading...
