D-Link DGS-1210 Series - Step 2 - IP Information

4 Web-based Switch Configuration D-Link Smart Managed Switch User Manual
2
2
7
7
Web Mode
Select the Standard Mode to continue the following settings or select
the Surveillance Mode to continue the Smart Wizard in Surveillance
Mode.
Click Next to enter the next configuration page.
Step 2 – IP Information
The IP Information page allows the user to configure IP address assignment method, the static IP address,
netmask and gateway address.
Figure 4.2 – IP Information in Smart Wizard
The fields that can be configured are described below:
Item Description
Static The method to configure the parameters of the IP interface manually.
DHCP The method to configure the IP interface to DHCP mode.
BOOTP The method to configure the IP interface to BOOTP mode.
IP Address The field to enter the value of IP address.
Netmask The field to enter the value of subnet mask.
Gateway The field to enter the value of default gateway IP address.
Click Next to enter the next Password setting page.
Tick the Ignore the wizard next time option to skip the Smart Wizard on the next login.
NOTE: The Smart Wizard supports quick settings for IPv4 network.