1 Product Introduction D-Link Smart Managed Switch User Manual
10
NOTE: On the DGS-1210-28, the MiniGBIC ports are shared with
normal RJ-45 ports 25T, 26T, 27T and 28T. When the MiniGBIC
port is used, the RJ-45 port cannot be used.
CAUTION: This product is intended to be use w
Optical Transceiver product, Rated DC3.3V, Laser Class I.
ATTENTION:
Ce produit est destiné à être utilisé avec un
transceiveur optique homologué UL,tension DC3.3V, classe laser
I.
CAUTION: The equipment power supply cord shall be connected
to a socket-outlet with earthing connection.
Le cordon d'alimentation de l'équipement doit être
branché sur une prise de courant dotée d'une connexion à la terre.
NOTE: Once user enter in loader mode, please
(standa
lone version 2.0.2.4 only (No support by Chrome
DNA3.x.x.x)) to download the image for recovery, or call D-Link
Technical Support for further assistance.
Rear Panel
Figure 1.12 – DGS-1210-28 Rear Panel
Power: Connect the supplied AC power cable to this port.
DGS-1210-28P
24-Port 10/100/1000Mbps plus 4 Combo GE/SFP Smart Managed PoE Switch.
Front Panel
Figure 1.13 – DGS-1210-28P Front Panel
The front panel of the DGS-1210-28P switch consists out of the following:
• Power LED
: The Power LED lights up when the Switch is connected to a power source.
• Fan Error: The FAN LED shows the status of the fans, light off indicates all fans work fine and the red
light indicates that one or multiple fans are working abnormally.
• PoE Max: The PoE Max LED lights up with solid red when the Switch reaches the maximum power
budget defined by the administrator via PoE System Settings page of Web GUI or the default power
budget of 193 Watts.
To Next Page
Loading...
