D-Link DGS-1210 Series - Firmware and Configuration Management Commands

6 Command Line Interface D-Link Smart Managed Switch User Manual
150
configured.
Restrictions None.
Example usage:
To upload a firmware file:
DGS-1210-52MP>upload firmware_toTFTP 1.1.1.23 1\running—config image_id 1
01–Jan–2000 01:26:11 %COPY–I–FILECPY: Files Copy – source URL running–config
destination URL tftp://1.1.1.23/1\running–config
…..01–Jan–2000 01:26:16 %COPY–W–TRAP: The copy operation was completed success
fully
!
158 bytes copied in 00:00:05 [hh:mm:ss]
DGS-1210-52MP>
config firmware
Purpose To configure which firmware image to be boot up.
Syntax config firmware image id <integer (1-2)> boot_up
Description The config firmware image id
command configures the
firmware image to be boot up on the Switch.
Parameters <integer (1-2)> − Specifies the image 1 or 2 to be configured.
boot_up – Specifies the specified image to be boot up.
Restrictions None.
Example usage:
To configure the firmware image id 1 to be used when boot up on the Switch:
DGS-1210-52MP> config firmware image_id 1 boot_up
DGS-1210-52MP>
config configuration
Purpose To specify which configuration file to be configured.
Syntax config configuration config_id <integer (1-2)> {delete |
boot_up}
Description The config configuration command configures the configuration
image to be deleted or boot up on the Switch.
Parameters config_id <integer (1-2)> −
Specifies the image 1 or 2 to be
configured.
{delete | boot_up} – Specifies the configuration
image to be
deleted or boot up.
Restrictions None.
Example usage:
To configure the configuration image id 1 to be used when boot up on the Switch: