6 Command Line Interface D-Link Smart Managed Switch User Manual
1
1
5
5
3
3
--- 10.90.90.91 Ping Statistics ---
3 Packets Transmitted, 3 Packets Received, 0% Packets Loss
DGS-1210-52MP>
Purpose To test the connectivity between network devices.
Syntax ping6 <ipv6addr>
Description The pingv6 command checks if another IP address is reachable
on the network. You can ping the IP address
connected to
through the managed VLAN (VLAN 1 by default), as long as
there is a physical path between the switch and the
equipment. By default, Switch sends five pings to the target IP.
Parameters <ipv6addr> − The IPv6 address of the host.
Restrictions None.
Example usage:
To ping the IPv6 address 3000::1:
DGS-1210-52MP> ping6 3000 ::1
Reply Received From : 3000 ::1, TimeTaken : 20 msecs
Reply Received From : 3000 ::1, TimeTaken : 20 msecs
Reply Received From : 3000 ::1, TimeTaken : 20 msecs
--- 3000 ::1 Ping Statistics ---
3 Packets Transmitted, 3 Packets Received, 0% Packets Loss
DGS-1210-52MP>
Purpose To reboot the Switch. If the Switch is a member of a stack, it may
be rebooted individually, without affecting the other members of
the stack.
Syntax reboot
Description The reboot command
reboots the system. All network
connections are terminated and the boot code executes.
Parameters None.
Restrictions None.
Example usage:
To restart the Switch:
DGS-1210-52MP> reboot
% Device will reboot, please wait a few minutes to re-login.
DGS-1210-52MP>
To Next Page
Loading...
