D-Link DGS-1210 Series - Reset Config; Show Boot_File; Show Firmware Information

6 Command Line Interface D-Link Smart Managed Switch User Manual
154
reset config
Purpose To reset the Switch to the factory default settings.
Syntax reset config
Description All configurations will be reset to the default settings.
Parameters None.
Restrictions None.
Example usage:
To restore all of the Switch’s parameters to their default values:
DGS-1210-52MP> reset config
% Device will reboot after reset configuration successfully.
DGS-1210-52MP>
show boot_file
Purpose To display the information of the boot file on the Switch.
Syntax show boot_file
Description The show boot_file command displays the current information of
boot file on the switch.
Parameters None.
Restrictions None.
Example usage:
To the information of the boot file on the Switch:
DGS-1210-52MP> show boot_file
Bootup Firmware : image_1
Bootup Configuration : config_1
DGS-1210-52MP>
show firmware information
Purpose To display the firmware information on the Switch.
Syntax show firmware information
Description The show firmware information command displays the current
firmware information on the switch.
Parameters None.
Restrictions None.
Example usage:
To the firmware information on the Switch:
DGS-1210-52MP> show firmware information