D-Link DGS-1210 Series - System and Network Settings

4 Web-based Switch Configuration D-Link Smart Managed Switch User Manual
3
3
9
9
RSTP: Click Settings to link to L2 Functions > Spanning Tree > STP Global Settings. Default is disabled.
Port Mirroring: Click Settings to link to L2 Functions > Port Mirroring. Default is disabled.
Storm Control: Click Settings to link to Security > Storm Control. Default is disabled.
DHCP Client: Click Settings to link to System > System Settings. Default is disabled.
Jumbo Frame: Click Settings to link to L2 Functions > Jumbo Frame. Default is disabled.
SNMP Status: Click Settings to link to SNMP > SNMP > SNMP Global Settings. Default is disabled.
802.1X Status: Click Settings to link to AAA > 802.1X > 802.1X Settings. Default is disabled.
Safeguard Engine: Click Settings to link to Security > Safeguard Engine. Default is enabled.
IGMP Snooping: Click Settings to link to L2 Functions > Multicast > IGMP Snooping. Default is disabled.
Power Saving: Click Settings to link to System > Power Saving. Default is disabled
System > System Settings
The System Setting allows the user to configure the IP address and the basic system information of the
Switch.
Figure 4.26 – System > System Settings
IPv4 Information: There are three ways for the switch to obtain an IP address: Static, DHCP (Dynamic Host
Configuration Protocol) and BOOTP.
When using static mode, the Interface Name, VLAN Name, Interface Admin State, IPv4 Address,
NetMask and Gateway must be manually configured. When using DHCP mode, the switch starts DHCP
procedure by click Apply. By default the IP setting is static mode with IP address is 10.90.90.90 and subnet
mask is 255.0.0.0.
DHCP Option 12 State: Specifies the DHCP option 12 state is enabled or disabled.
DHCP Option 12 Host Name: Specifies the host name for DHCP.
DHCP Retry Times: Specifies the retry time of DHCP.
System Information: System Name and System Location can be configured by custom strings which
helps the device can more easily be recognized through the SmartConsole Utility and from other Web-Smart
devices on the LAN.